| The following is a list of tools that will be helpful when assembling your RANS S-19. printable version |
| |
| HAND TOOLS |
| Pliers |
Safety Wire Pliers |
| Needle-Nose Pliers |
Vise Grip Pliers |
| Needle-Nose Vise Grip Pliers |
Side Cutters |
| Wire Strippers |
Small Spring Clamps |
| Aviation Snips |
Hand Pop-Rivet Tool |
| Hammers |
Click Punch |
| Rubber Mallet* |
Screwdriver Set - SAE & Metric |
| Several Small Clamps |
Safety Glasses |
| Wrench Set SAE & Metric |
Socket Set - SAE & Metric |
| Ruler & Tape Measure |
2 or 4 ft. Level |
| Adjustable Fly Cutter* |
Utility Knife |
| Set of Drill Bits (sizes listed below) |
Files |
| Deburring Tool |
Scotch-Brite Pads |
| Cleco Pliers |
Digital Protractor |
| |
|
| POWER TOOLS |
| Electric Hand Drill |
Small Electric Grinder |
| Dremel* |
Bench Disk Sander* |
| Soldering Iron |
Heat Gun* |
| CD Player* |
Right Angle Drill and Bits |
| |
|
| It is highly recommended that you use a pneumatic riveter. These are the pneumatic riveters that we use at RANS. |
| |
| •Marsen V2 Lightweight pneumatic riveter P/N 79014 |
| •MSC Industrial Supply Co. P/N 04053278 |
| |
| LUBRICANTS & ADHESIVES |
| Small Can Lithium Grease |
Clear Silicone |
| Contact Cement |
WD40 |
| Super Glue |
Lubricating Oil |
| Drill Lubricant |
Glue Stick |
| |
| CLECO FASTENERS |
| The following are considered minimum quantities. |
| |
| 3/32" (Cadmium or Silver) |
200 |
| 1/8" (Copper) |
200 |
| 5/32" (Black) |
20 |
| 3/16" (Brass or Gold) |
20 |
| |
| DRILL BIT SIZES |
| A Unibit® Step Drill ranging from 1/4" to 3/4" and conventional bits ranging from 1/8" to 3/8" is strongly recommended. |
| |
| In Addition to these the following bits will be required to assemble your S-19 |
| |
| CONVENTIONAL BITS |
RIGHT ANGLE |
| #50 |
#40 |
| #40 |
#30 |
| #30 |
#11 |
| #28 |
|
| #21 |
|
| #11 |
|
| 1/2" & 3/4" Unibit® Step Drill |
| |
| REAMS |
| 0.1885" |
| 0.375" |
| |
| TOOLS AND MATERIALS NEEDED FOR CASTING LEAD BALLAST WEIGHTS |
| Hot Plate |
Lead Flux |
| Stainless Steel Spoon |
Scale |
| Scrap Wood |
Screws or Clamps |
| Lead (Tire shops are a good source) |
Safety Glasses |
| Respirator |
Welding Apron and Gloves |
| Crucible (Or small sauce pan able to withstand 900 degrees) |
|
| |
| *Indicates optional items. These are not required but may make building easier. |
