Parts manual shows 8 aapq62 rivets in front spar, can't figure out where they go?
Steve
Search
New Posts
- QuestionThe text manual on page 85 details installing the brake system. In item 1, it says the fuse should be on the main gear. It must be assumed that the bolts holding the gear on are already installed. In item 9, it says to press the brake line into the groove in the aft side of the gear leg. Question------do I remove the aft bolt holding the gear in place, install the brake line in the groove then replace the bolt, or does the brake line go to the outside of the bolt??? The detail for the belly fairing (figure 08-01) does not show any clearance or hole to accommodate the brake line if it is not in the gear leg groove, only an opening to allow the gear leg itself. Guidance please.
- DiscussionManual says to leave boot Cowl off till after painting! What is the purpose of this? Maybe for installing windscreen? Can you not just install everything and just mask the windscreen or is there something else you need the Cowl off for? Steve
Well figured out my parts manual was a old one, no aapq62 on ft spar!
Steve, that is correct, the larger rivets were used to fill the hinge holes in the front spar, spars used to be the same front and back, now there is a forward and an aft spar.