May 9

Garmin/Dynon pitot mount?

6 comments

G'day - was wondering if you could take some pictures around how you have supported the pitot mount - both inside and outside if possible...

 

Thanks!

 

May 13Edited: May 13

Hi Jase, hope these photos help, let me know if you need anything else.

 

 

 

 

Thanks for posting the photos, I will be installing something similar in the next couple days.

 

Is that a Gretz mount?

 

 

May 13

Yes, it is a Gretz.

May 13

Awesome - thx

May 13

Also - hadn't thought to put the AOT sensor there too.... So there is no part of that doubler attached to the rib? What thickness is the doubler?

May 13

No part is attached to the rib, but it is butt up against it, provides ample support. The doubler is .040

New Posts
  • Manual says to leave boot Cowl off till after painting! What is the purpose of this? Maybe for installing windscreen? Can you not just install everything and just mask the windscreen or is there something else you need the Cowl off for? Steve
  • In the S21 progress report # 27 there is talk of an Assembly Alert for using VHB tape to install the lexan to the door frames. However, when I search for the assembly alert -----no joy. My kit did include the VHB tape, but there are no instructions on where to use it. It does not look like there is enough to do the entire perimeter of the door and the center seams, so I am wondering if it is only for the center seam. Or, anywhere the lexan meets the door frame? Guidance please.
  • Hi I am trying to make some room to clean out the boxes and stack the parts. I will need to make a rack. Can anyone tell me the wing skin sizes please the length and width. They will be the largest size so I can then make a multilevel rack to store the bits. I havent got the room at the moment to be able to unpack and store the bits safely so another rack inside the shed will have to be made. I need to get my inventory done asap
  • Facebook Clean
  • Twitter Clean
  • YouTube Clean

QUESTIONS?

CALL US AT 785-625-6346