So I followed the text and got this. The cowling starts to fit pretty good but the lower cowl does not fair into the spinner. So what’s up with that?
Search
So I followed the text and got this. The cowling starts to fit pretty good but the lower cowl does not fair into the spinner. So what’s up with that?
Ok I got it.
I made the gross assumption there would not be much trimming.
Boy was I wrong. Just follow instructions and it should work out fine.
Do you have a picture of your final fit?
It’s not complete yet. I was not satisfied with with the fit or design. I have been working with the Cubcrafters Super Cub series With basically the same Titan set up. They got very aggressive on increasing the volumetric air flow with some success. I am in the process of enlarging the intakes, adding inlet ramps to the top cowl and maybe a lip to the lower with an increase in exit area.